Regency 4734 Manual de instalación descargar pdf (Pagina 54)

Regency

Model 4734 Access Control Expander Installation Manual (P/N 150807, Rev. A) Revised 5/98

5.20 Default Options (Menu 19)

DEFAULT ALL?

If you select this option, all options will return to their factory-programmed default values.

WARNING! Selecting this option resets all options to their factory default values.

Section 6: Using the Model 5540 Downloading Soft-

ware

The Model 5540 Downloading Software allows you to use a computer at a remote location to

reprogram options and perform other functions for a particular installation. For more specific

information, see the Model 5540 Downloading Software Operation Manual (P/N 150481).

NOTE Software revision 3.3 is required for downloading.

Initial Download

During factory programming, the ANSWER RING option was selected (DIALER, Menu 7).

Once the panel is installed, the downloading computer can call it to download new program

data or request status information from the panel. After 10 rings (the factory programmed

value for the # RINGS option), the panel will answer the call and downloading will begin.

Subsequent Downloads

If the ANSWER RING option is still enabled, the computer can call the panel as described

above. Downloading can also be initiated from a touchpad at the installation location, by press-

ing 4 TEST followed by Code 0 or Code 1.

During uploading or downloading, the touchpad LCD will display “UP/DOWNLOAD.” Dur-

ing the downloading of options to the EEPROM, the LCD will also display address numbers.

Downloading of all options takes approximately 12 minutes. Downloading cannot take place

while the system is in alarm.

WARNING! During downloading, the system will NOT respond to alarms.

6.1 Starting and Ending

If you have just powered up the computer, enter the word “MODEM” first. If this has been

done since the computer was turned on, enter the word “PANEL” at the DOS prompt. Then

enter your user name and password when the prompts direct you to do so. The Panel Interface

Menu will appear.

To exit the Model 5540 downloading program, press ESC as many times as necessary, until

you see a prompt asking you if you want to leave the program.

6.2 Viewing Status

Status mode is used to view the status of the 4734 and to control functions as you would from

an on-site touchpad. The Status mode for the 4734 is different from that of the 4720 in that it

displays actual touchpad data on the remote computer. Therefore, the Status mode has access

to any status or function that is available on a standard touchpad.

1. Select Request Status on the Panel Interface Menu.

2. Initiate an upload, either by dialing the panel from the computer or by having someone

press 4 TEST on a touchpad at the account location.

3. The computer screen will begin to show the current touchpad display. The lower part of

the screen shows a simulation on the touchpad. Press the appropriate keys to accomplish

the desired functions.

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 69 70

Comentarios a estos manuales

Sin comentarios

Regency 4734 Manual de instalación Pagina 54

Comentarios a estos manuales