
Regency
®
Model 4734 Access Control Expander Installation Manual (P/N 150807, Rev. A) Revised 5/98
17
CODE#2:000000
Program the secret code or card PIN for this access code. The code can be from four- to six-
digits in length. If a card reader is connected, present the card to the reader.
NOTE Do not begin any codes with the same digits that are used for the duress trigger. The duress
trigger is programmed under SYSTEM (Menu 5).
5.3 Profiles (Menu 2)
NUMBER:
Select the profile to program (0-15).
ARS#0:12345678
Select the areas to which this profile may gain access by toggling the digits 1 through 8 ON
and OFF.
DOOR#0:YES
If this option is selected, this profile will be able to gain access to doors (within the areas
selected in the previous option). Press 0 for NO, 1 for YES.
NOTE The 4734 is not UL Listed for door access control.
BYPASS#0:YES
If this option is selected, this profile will be able to bypass (disable) intrusion zones.
ARM#0:YES
This option enables the profile to be used to arm (close) the system.
DISARM#0:YES
This option enables the profile to be used to disarm (open) the system.
PROGRAM#:YES
This option enables users with this profile to program the secret codes for codes with the same
ID or higher, and the user-programmable options (time windows, holidays, access options, and
daylight-savings time adjust dates).
CODE#0:NO
When this option is selected, the codes using this profile become restricted codes for use by
guests, baby-sitters, and other temporary users. This means that when the CODE2 key is
pressed, the code can disarm the system once. Normally, CODE2 restricted codes can never
disarm the system.
HIGH SEC#0:NO
When this option is selected, codes using this profile become high security codes. For Door
Access codes, which are high security require the code to be first entered with a card. Then the
user must enter the PIN of the card on the touchpad before access is granted.
CARD ONL#0:NO
The card only option allows access to a door to be gained only by a card, not by a touchpad.
The high security option overrides this option, because it requires that both presenting the card
and entering the PIN at the touchpad.
Comentarios a estos manuales