Regency 4734 Manual de instalación descargar pdf (Pagina 32)

Regency

Model 4734 Access Control Expander Installation Manual (P/N 150807, Rev. A) Revised 5/98

If a pause is needed, such as after dialing “1” for a long distance number, enter an “A” (0 1). If

an internal phone system is being used in which you must dial a special digit to establish an

outside line (and wait for a second dial tone), enter a “D” (0 4) after the digit to establish the

outside line. The procedure for entering alphabetic and other characters is explained in Section

4.5 of this manual.

NOTE The # and * keys cannot be entered directly. Use

7 3

for # and

8 0

for *.

EXAMPLE: If you must dial “9” before dialing the outside number of 555-3333, you

would enter “9D555-3333,” or “6 9 0 4 6 5 6 5 6 5 6 3 6 3 6 3 6 3.”

RETRY:NO

If this option is selected the system will try again to send a report 15 minutes after it has failed

its maximum number of attempts. If it fails all attempts again, it will not try another time.

LINE 2 EN:NO (Line 2 Enable)

Select this option if you are using two phone lines (requires the use of the Model 4175 Dual

Phone Line Monitor).

GROUND ST:NO

Select this option if you are using a ground start telephone network.

LINE MON:NO

Select this option if you will be using the Model 4175 Dual Phone Line Monitor. You can

monitor Line 1 only, if you do not have a second phone, but you cannot have both a monitored

line and an unmonitored line.

ANSWER RING:YES

Select this option if you wish to have the computer call the panel and download in the same

call. If you do not select this option, the communicator will wait until the phone stops ringing,

then dial up the computer for maximum security.

STORE OP/CL:NO

If this option is selected, the system will store opening and closing events until the next report

is sent. At that time, it will transmit all the events to the central station.

REP ALL O/C:NO

This option causes the system to report all openings and closings.

REP EXC O/C:NO (Report Openings/Closings at “Exceptional”

Times)

When this option is selected, the system will report openings and closings only if they occur

outside of specified time windows.

REP OT/CT:NO

Selecting this option causes the system to send an Open Trouble or Close Trouble Report to the

central station, if you fail to arm or disarm during a specified time window.

AUTO DUMP CS:NO

Select NO. This option is not available. Currently, the 5540 Downloading Software must be

used to dump event memory to the central station (see Sections 3.5 and 6 of this manual).

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 69 70

Comentarios a estos manuales

Sin comentarios

Regency 4734 Manual de instalación Pagina 32

Comentarios a estos manuales

Prodotti e manuali riguardandi Attrezzi elettronici Dewalt DW712